Midmark M11 Autoclave Sterilizer Red Display *Refurbished*

Midmark M11 Autoclave Sterilizer with Red Display 

With this Autoclave, the door opens automatically and quietly to release steam

Self Program Controls
Programmable controls allow for creation of different cycle parameters for special sterilization needs. Programmable buttons allow you to change the following: Time (3 to 90 minutes), Temperature (230 to 275º F), Dry Time (0 to 60 minutes), Vent (slow or fast) and two program buttons. The #1 and #2 buttons allow you to store the change if desired.

Pre-Programmed Controls
Four pre-programmed sterilization cycle controls: Unwrapped (132º C or 270º F for 3 minutes), Pouched (132º C or 270º F for 5 minutes), Packs (121º C or 250º F for 30 minutes), Handpiece (Dental Handpiece use only)

LCD Display
Indicates cycle selected, temperature and exposure time for selected cycle. During the cycle, the display shows messages describing status of cycle. When the cycle enters sterilization mode, remaining time is displayed as well as temperature and pressure.

Cycle Start
(Initiates selected cycle)

Manual Stop
(Terminates selected cycle or function)

Overall Dimensions: 22.38 D x 17.62W x 17.56H

• Countertop area: Minimum depth 21 inches
• Chamber size: 11inches
• Dia - 18 inches
• 6.5 gal. usable volume
• Trays: Two large - 15L x 9.12W x 1.12D, Two small - 15L x 6.62W x 1.12D
• Water reservoir capacity: 1.25 gallon
• 115 VAC, 50/60 Hz, 15 A Single Phase

â–º CLICK HERE TO VIEW CARE AND USE DOCUMENT

MIDMARK AUTOCLAVE Maximum Weight Loads
In order to perform sterilization cycles, there is a maximum weight of instruments you can place in autoclaves. For optimal performance it is recommended to spread the load among all the trays.
When autoclaves are overloaded, chances are the cycle will fail and have to be repeated.